V-belt is an important tool for many mechanical transmission, has a relatively good results, mainly rely on friction to make the normal operation of the V-belt pulleys. In general, we use the time to choose the right model triangle belt pulleys, then choose what basis is it? In fact, choose the pulley tape tape velocity model is based on power delivered to the decision. Next, we will look at it together. Selecting the right triangle pulley model: Select the model chosen triangle tape should adapt, otherwise triangle belt pulley groove abnormal situation occurs, when switching to triangle tape, to bring the best of the old to the agricultural sector to buy, to prevent the wrong type. V-belt is installed correctly: Before installation, if the two-axis center distance is adjustable structure, should first center distance shorter tape installed before adjusting the center distance required; if the two axis center distance is not adjustable, you can a belt will be set into the round slot to go, then turn another pulley, the upper triangle tape loaded, using the same method to a set of triangular tape are fitted. Prohibit installation tools hard to pry, pull hard on the belt, to prevent elongation triangle tape too tight or too loose phenomenon. V-belt prevent channeling: When installing a pulley, center on the two pulleys must be aligned, otherwise it will create a triangular tape unilateral work, badly worn lower triangle belt life. Elastic to fit: tightness triangle tape must always check adjusted to conform to the requirements. Belt too loose not only slippery, but also increased belt wear, can not even transfer power; too tight, not only will the belt stretching deformation, easy to damage, but also cause clutch bearings due to the force of the engine main bearing is too large, accelerated belt wear. 

keywords: The pulley, the pulley, the pulley,